Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem somewhat old-fashioned but it's still striking. It might not be the most luxurious car in its class - it's a Ford Focus or Volkswagen Golf will protect you from road imperfections, but it's a relaxed and pleasant drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will aid in solving the issue whether it is constant or intermittent.
Water Damage
If you accidentally drop your key fob in an eddy, or it is wet while kayaking, canoeing or rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outside or engage in activities that expose it to a lot of water.
You'll also need to ensure that the fob is completely dry prior to opening it and reusing it. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's been submerged.
A circuit board that's wet can cause the battery to lose its charge or even explode. If you can pull your keyfob 308 from the water it is best to turn the button side up and shake as much water as possible before opening the casing. Once you have opened it, take out the battery and clean the circuit board with an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not work include a dead coin-cell battery or receiver module issues signal interference or a faulty chip. If peugeot 207 key replacement www.g28carkeys.co.uk of these are the problem it is possible to reset the system by disconnecting a 12 voltage battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows drivers to start their car from the distance, allowing them to warm up or cool down the vehicle before entering. This feature is extremely helpful, especially during cold winter months. However, it is possible that the remote start system stops working due to a variety of causes, such as a dead coin battery.
A coin-shaped battery that is found inside the key fob has a lifespan of two to four years, based on how often used and where it's purchased. The date of use is printed on the package or marked in the user's manual.
If the key fob is not functioning after exposure to water that is clean and you want to remove the battery, then clean the chip using a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If exposed to salty or soapy water, the chip may be fried and you will need to replace the key fob in total.
If you are not sure the battery is in good condition, you can test its voltage with a multimeter set to your vehicle's voltage range and connected to the minus and plus terminals. If the voltage is less than 12-13 volts then you need to replace the battery. If you want to, you can attempt to reset the onboard computer by disconnecting the battery with 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.
Faulty Receiver Module
If you don't see the "Key Detected" you might find the receiver module not working properly. It's the component that sends an indication to the car when your key fob is activated, it also acts as an immobiliser and prevents it from starting unless the correct key is in place.
This could be due to a number of causes including water damage or simply aging. If the electronic chip in your Peugeot 308 keyfob is damaged by dirty tap water it could be because the keyfob was exposed it. In this case you'll have to take the unit apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. Once it's dry you can put the battery back in and test it again.
If the problem persists it is a good idea that you visit the local Peugeot expert or locksmith. They'll make use of a diagnostic device to assist in identifying the problem and repair it for you.
The loss of your Peugeot keys to your car can be a stressful experience. A qualified auto locksmith will be able to resolve the issue within minutes. They can program your vehicle and cut a brand new, functioning key for you. Click here to find the nearest locksmith.
Faulty Electronic Chip
The chip inside the Peugeot 308 key fob is a very crucial component of the remote control system. If it is damaged your car may not start, or you could receive a message stating "anti-theft active". If this occurs, the only way to fix the issue is to get a new key. Auto locksmiths with experience are able to provide this service within the shortest possible time.
The chip inside the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or any other cause. If your Peugeot key fob has been exposed to dirty or soapy water, it should be cleaned promptly. You can use a paper towel and isopropyl alcohol to wipe the electronic component. The battery must then be allowed to dry completely.
Radio interference can cause the key fob to stop functioning. This can happen when other devices operate on the same frequency as your Peugeot keyfob. This could be due to problems with the environment or objects close to the vehicle. If you encounter this issue, it is best to visit a Peugeot dealership.
The Peugeot key fob 207/308 is very delicate and requires care. It should not be dropped or throw it around. If you lose it, try to locate it as quickly as you can. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative cable first, and then the positive.